Xinysun Instrument (Shanghai) Co., Ltd.

Solutions

Breadcrumb: Home > Solutions > Speed Measurement

Speed Measurement

Speed measurement solutions: the boundaries of contact and non-contact measurement, laser tachometer sensors and reflective marks, stroboscopic harmonic reading and the divide-by-2 check, panel tachometer display, alarms and RS485 data upload, and how this applies to long-duration test stand recording, motor balancing, line speed verification and predictive maintenance of rotating equipment, with selection tables, setup and reading troubleshooting.

  • Bench Tachometry Above 10,000 rpm: Why R

    2026-11-09 Centrifugal acceleration, not rpm alone, decides when reflective tape leaves a rotor. Work out the crossover for your radius and switch to paint.
  • 20 Questions About LED Stroboscopes: Fre

    2026-10-31 A flash rate matched to motion freezes moving parts while showing speed. Twenty answers cover aliasing, sub-harmonic lock, triggering, power and calibration.
  • ROS-W/ROS-P and ROLS-W/ROLS-P Tachometer

    2026-10-28 Intermittent pulses and jumping displays trace to wiring, gap or supply, not the sensor. Separate W and P variants and run a bench test before replacing.
  • Drone Propeller Speed Measurement with t

    2026-10-26 Propeller speed varies with throttle, voltage and load, so a stand needs reliable rpm for thrust curves. A laser sensor resists sunlight and ESC noise.
  • Laser Tachometer Sensor Wiring and Outpu

    2026-10-26 Laser tachometer wiring by output type: 5V TTL, NPN and PNP open collector, 24V TTL and BNC, with pinouts for panel meters, PLCs and data loggers.
  • How to Choose a Laser Tachometer Sensor?

    2026-10-26 Pick laser or LED by distance, set range and offset angle, then wire 5V TTL or PNP into a PLC. ROLS-5PW figures, reflective tape and mounting rules.
  • How to Choose a Stroboscope? LED vs. Xen

    2026-10-25 Flash duration, frequency range and trigger mode decide whether you see a crisp frame or a blur. Four LUYOR-906 models compared, 60-300,000 flashes/min.
  • Stroboscopic Observation of High-Speed M

    2026-10-21 Match flash rate to pattern period for printed webs, align register with phase trim, and read reciprocating or vibrating parts. LUYOR-906L settings inside.

Further Reading

· Selection and Brands: Tachometer Sensor Selection Guide: Laser, Photoelectric and Self-Powered, How to Choose Speed Measurement: Tachometers and Sensors Compared

· Operation and Interpretation: How to Read Stroboscope Speed Measurements Accurately: Harmonic Interpretation and the ÷2 Verification Method, Xenon or LED Stroboscope? Flash Duration Determines How Clearly You Can See

· Field Applications and Case Studies: Bench Speed Measurement Above 10,000 RPM: Why Reflective Stickers Don't Stay On and How to Mark with a Pen, Drone Propeller Speed Measurement: ROLS-5PW Frequency-Modulated Laser with Anti-Light Interference and Synchronized Bench Data Acquisition

Copyright 2026 Xinysun Instrument (Shanghai) Co., Ltd. All rights reserved.
ICP:ICP-2026046447

SiteMap

Official WeChat QR code

WeChat QR
Official WeChat QR code Follow

Official WeChat QR code

Contact

131-2093-6518

Top