Breadcrumb: Home > Applications > Lab Research
Updated:2026-11-02
Views: Producing transgenic material is no more than the starting point; the next question is plainer - which of these resistant calli actually carry the transgene, and which express it uniformly. A study on rubber tree somatic embryogenesis published in International Journal of Molecular Sciences in March 2024 used the LUYOR-3260RB fluorescence protein excitation source to turn that answer into green fluorescence visible to the eye. This article follows the workflow of that study, from callus induction and Agrobacterium-mediated transformation through antibiotic selection to confirmation of transgenic lines, and sets out what a handheld excitation source contributes at the screening step: whole-plate scanning through the culture vessel, a binary read of whether a callus glows at all and whether it glows evenly, and no contact with the material.
Producing transgenic material is no more than the beginning. The question that follows is a plain one: which of these resistant calli actually carry the transgene, and which of them express it uniformly? A study published in March 2024 in International Journal of Molecular Sciences (Tang Chaorong / Cao Jie team, College of Tropical Crops, Hainan University) used the LUYOR-3260RB fluorescence protein excitation source to turn the answer to that question into green fluorescence visible to the eye. This article follows the workflow of that rubber tree study and sets out how a handheld excitation source is used for positive identification of plant callus.
Hevea brasiliensis is the main source of natural rubber, and gene function work depends on genetic transformation, where low regeneration efficiency is the bottleneck. The team focused on two genes:
Those fold changes hold if the material is a transgenic callus line that is both paromomycin-resistant and uniformly GFP-fluorescent - and that gate was kept by the LUYOR-3260RB.
The pCAMBIA2300 destination vector used in the paper carries two selectable markers: neomycin phosphotransferase II (NptII, conferring paromomycin resistance) and green fluorescent protein (GFP), both driven by the 35S promoter. Screening after transformation ran in two steps:
Why the second step cannot be skipped: antibiotic resistance shows that the selectable marker gene is working, and nothing more. It does not separate "integrated and expressing" from "escaped and surviving", and it cannot identify a chimera in which fluorescent and non-fluorescent cells are mixed inside one callus piece. Figure 3b of the paper shows this directly: arrow 1 points to non-fluorescent callus, arrow 2 to GFP-fluorescent callus, and screening is the cut between the two.
After 63 days of selection culture, the team obtained 2 HbGRF4 lines and 8 chimera lines from C073, and 4 and 2 from C363; all transgenic lines were confirmed by RT-PCR to express HbGRF4 at a high level. The later embryo yield counts and transcriptome sequencing (mature embryos at stage E75, 1361 and 1631 differentially expressed genes) drew on exactly these fluorescence-confirmed pure GFP lines and mature embryos.
Callus grows in culture vessels and cannot be carried to a microscope. A transgenic callus population is tens to hundreds of small pieces spread over the medium surface - small, friable and dependent on sterile conditions. A handheld excitation source illuminates through the vessel wall, scans a whole plate in one pass, and touches nothing; screened callus goes straight back to the shelf and keeps proliferating.
Whole-plate scanning beats a microscope on throughput. The LUYOR-3260RB produces a spot about 150mm across at a distance of 30cm, covering a 9cm dish in one pass. Confirming whether a whole callus piece glows evenly calls for fast visual review of many pieces, not structural inspection of individual cells - which is where a handheld source fits.
The question is presence and evenness, not localization. A fluorescence microscope answers subcellular localization questions, while initial screening of transgenic lines needs a binary judgment: bright or not, uniform or mottled. Nine 3W deep-blue LEDs (440-460nm, nominal 450nm) excite GFP, and with 500nm long-pass viewing glasses the green signal is visible by eye against a dark background, with no substrate needed.
Battery power, usable at the bench. The unit weighs about 455g including a 12V 2600mAh lithium battery and runs about 2-4 hours continuously, so it moves from the culture shelf to the clean bench without a fixed workstation. It starts instantly with no warm-up, and the screening rhythm follows the experiment.
According to the methods section of the paper, the LUYOR-3260RB sits in this chain:
Note that the later RNA-seq sampling used the same standard - mature embryos carrying a pure GFP signal from lines 363-p35S:GFP, 363-p35S:HbGRF4-3 and 363-p35S:HbGRF4-HbGIF1-1. How rigorous the fluorescence screening is decides how credible the omics data are.
The RB deep-blue band (440-460nm, nominal 450nm) matches green fluorescent systems such as GFP, eGFP, fluorescein, calcein and Lucifer Yellow, with 500nm long-pass viewing glasses. The LUYOR-3260 is a single-wavelength series with four other bands - UV (365nm, for DAPI/Hoechst), LB (488nm), CY (505nm, for YFP) and GR (520nm, for DsRed/RFP) - ordered according to what is being observed.
Resistance shows that the selectable marker is working and nothing more; escapees can survive as false positives. Fluorescence detection confirms that the reporter gene is really expressed and identifies chimeric callus in which fluorescent and non-fluorescent cells are mixed. A line has to be both resistant and uniformly fluorescent before it is sound enough for expression analysis and phenotypic counting.
No. Illuminating through a transparent vessel or dish is enough - non-contact, non-destructive, and the material can keep growing afterwards. That is also why a handheld excitation source can stand in for moving a microscope: the callus stays where it is and the light comes to it.
Start by subtraction: turn off direct light in the field of view, draw the blind, and confirm the filter glasses match the cut-off wavelength. Then fix the working distance (about 30cm) and the angle so every piece is exposed the same way. If needed, split the reading into two independent screens and take the intersection, with an untransformed control alongside to calibrate background.
The 3260 series are single-wavelength handheld lamps, one band per fluorescent system, with portability as the priority; the 3415RG is a dual-wavelength handheld lamp covering GFP and red fluorescence in one unit; the 3421 is a bench source for a fixed workstation with a stereo microscope for close inspection. A common combination is handheld initial screen plus bench close check.
The 3260RB uses a replaceable 12V 2600mAh lithium battery, runs about 2-4 hours continuously and charges in about 2-6 hours, with a 110-260V AC adapter supplied. For several rounds back to back, keep a spare battery or run directly from the adapter.
This rubber tree study provides a clear demonstration: in a plant transformation pipeline, fluorescence screening is not a side step but the quality gate that decides the standing of every later phenotype and omics data set. The value of a handheld excitation source such as the LUYOR-3260RB is that it moves GFP reading from the microscope bench to the culture shelf - a vessel of callus in a few tens of seconds, and the screened material keeps growing. If you need to confirm a specific fluorescent system or material type, contact our technical colleagues.
Source: Luo X, Zhang Y, Zhou M, Liu K, Zhang S, Ye D, Tang C, Cao J. Overexpression of HbGRF4 or HbGRF4-HbGIF1 chimera improves the efficiency of somatic embryogenesis in Hevea brasiliensis. Int. J. Mol. Sci., 2024, 25(5): 2921. DOI: 10.3390/ijms25052921 (open access, CC BY 4.0; experimental details follow the original paper).
This article belongs to the lab research techniques section.
Other sections on the same product line include GFP fluorescence flashlights (models split by GFP/RFP/DsRed band, handheld and bench) and surface inspection lamps (low-angle side light that pulls particles, scratches and fingerprints out of the background) and life science instruments (the entry point for fluorescence imaging, UV crosslinking, UV transmission and cell irradiation).
Models mentioned in this article: LUYOR-3260RB, LUYOR-3260, LUYOR-3415RG. Ranges, accuracy and accessory lists for each model are listed on the product page.
Email: info@xinysun.com
Tel: 131-2093-6518
Address: 1525 Minqiang Road, Bldg 26, Songjiang, Shanghai
Copyright 2026 Xinysun Instrument (Shanghai) Co., Ltd. All rights reserved.
ICP:ICP-2026046447
